← Back to Capture Sequencer

Capture Sequencer guide

Capture Sequencer solves two complementary problems: building a sequence from the available time, or calculating the duration and end time of an existing NINA sequence.

01

1 · Two calculation modes

“Start from available time” finds the greatest number of lights that fits within the stated duration while keeping complete, identical iterations and approximating the filter proportions.

“Start from a NINA sequence” does not distribute time: it uses the exact iterations and lights per filter entered, then calculates integration, total duration and end time. Switching modes must not alter entered values.

02

2 · Automatic operations

“Dither every” sets the total number of lights between dithers. The counter is global: it continues across filter changes and resets only when a new sequence starts. No dither is added after the final light. The measured reference is every 4 lights with 22 additional seconds for movement and guide recovery.

“Readout and preparation between lights” represents the interval from the end of one exposure to the start of the next without attributing it to file saving. The reference value is 6 seconds and applies only when another light remains.

The initial autofocus is counted before the first photograph. Later runs are time-based and the timer does not reset with a filter change. The reference duration is 235 seconds. “Filter change and refocus” retains 5 seconds for the change and focus offset.

03

3 · Starting from available time

Enter the complete session duration, exposure per light and number of identical iterations. Total duration includes exposures and auxiliary operations.

Select filters and assign their proportions. Their sum cannot exceed 100%. Percentages are a preference: integer counts approximate them so every selected filter is retained and precisely the same distribution is repeated in each iteration.

04

4 · Starting from a NINA sequence

Enter the start time, exposure duration, iterations and lights per iteration for each filter. This mode reproduces the entered sequence without redistributing captures.

Enable the meridian-flip option when required. One fixed six-minute block is added and already includes the subsequent autofocus so it is not counted twice. End time includes seconds and indicates when it falls on the following day.

05

5 · Filters and iterations

CLS, R, G, B, Hα, OIII and SII can be enabled. Only selected filters appear in the distribution. Available-time mode shows proportions; NINA mode shows lights per iteration.

An iteration is one complete pass through the selected filter blocks. The next iteration repeats the same blocks and quantities.

06

6 · Reading the result

“Total lights” and “Effective integration” count exposures only. “Estimated duration” adds readout and preparation, autofocus, dithers, filter changes and refocus, plus the meridian flip when enabled.

“Capture breakdown” separates one-iteration figures from totals across every iteration. “Overhead” shows how often each operation runs and its combined duration.

07

7 · Retaining data

The selected mode, time, exposure, iterations, filters, proportions, lights and meridian-flip choice are stored locally in this browser. Automatic-operation values are retained as well.

No data is sent to a server. Values change only when you edit them or the browser clears local storage.

08

8 · Model and limits

The calculation assumes that the stated exposures and operations complete successfully. Failed autofocus runs, retries, guiding losses, cloud, hardware errors and manual intervention cannot be predicted.

File saving adds no separate time. The 6 seconds between lights represent the observed camera and NINA readout/preparation cadence. Comparing an actual session requires the NINA logs so exceptional events can be measured.

← Back to Capture Sequencer